<sub id="a8h0n"><listing id="a8h0n"></listing></sub>
      <strike id="a8h0n"><pre id="a8h0n"></pre></strike>

      歡迎光臨濟南九創門業有限公司官網!

      聯系我們 收藏本站 在線留言

      新聞資訊

      首頁>>新聞資訊>>濟南車庫門淺談造成電動卷簾門邊角脫落的原因?
      新聞資訊
      聯系我們
      濟南九創門業有限公司

      聯系人:李經理

      電話:15006519345

      網址:www.halc9bit.com

      地址:濟南市天橋區北園大街372號大明家居3F-A-10

      濟南車庫門淺談造成電動卷簾門邊角脫落的原因?

      來源:http://www.jnhsjlm.com 日期:2020-11-04 發布人:guanli
      其實,使用過電動卷簾門的顧客們都知道其使用一段時間之后,會出現變焦脫落的現象,那大家知道造成此現象的原因有哪些嗎?接下來,濟南車庫門卷簾門廠家將在下文為大家介紹一下,希望能幫到大家。
      In fact, the customers who have used the electric rolling shutter door know that the zoom will fall off after using for a period of time. Do you know what causes this phenomenon? Next, Jinan garage door rolling shutter door manufacturers will be introduced below, hoping to help you.
      1、應保證電動機在運行過程中良好的潤滑。一般的電動機運行5000小時左右,即應補充或更換潤滑脂,運行中發現軸承過熱或潤滑變質時,液壓及時換潤滑脂。
      1. The motor shall be well lubricated during operation. The general motor runs for about 5000 hours, that is, the lubricating grease should be supplemented or replaced. When the bearing is overheated or the lubrication is deteriorated, the hydraulic pressure should change the lubricating grease in time.
      更換潤滑脂時,應清除舊的潤滑油,并有汽油洗凈軸承及軸承蓋的油槽,然后將ZL-3鋰基脂填充軸承內外圈之間的空腔的1/2(對2ji)及2/3(對4、6、8ji)。
      When replacing the grease, the old lubricating oil should be removed, and the oil groove of bearing and bearing cover should be cleaned with gasoline. Then, zl-3 lithium grease should be filled into 1 / 2 (for 2ji) and 2 / 3 (for 4, 6 and 8ji) of the cavity between the inner and outer rings of the bearing.
      2、清潔簾布時,采用軟的棉布擦拭,用硬幣很容易劃傷表面,污跡太重時,可以使用清洗劑、牙膏、專用清洗劑等。去污后用清水擦拭,然后擦干,正確的清潔方法能夠使快速卷簾門始終保持亮麗如新。
      2. When cleaning the cord fabric, use soft cotton cloth to wipe it. It is easy to scratch the surface with coins. When the stain is too heavy, you can use cleaning agent, toothpaste, special cleaning agent, etc. After decontamination, wipe with water, and then dry, the correct cleaning method can make the fast shutter door always keep bright as new.          
                     濟南車庫門
      3、電動卷簾門體在運行的時候,門體下方禁止有小孩或物品,以免運行過程中傷到小孩或物品。
      3. When the electric rolling shutter door body is running, there are no children or objects under the door body, so as to avoid injury to children or articles during operation.
      4、當電動機的熱保護連續發生動作時,應查明故障來自電動機還是超負荷或保護裝置整定值太低,消除故障后,方可投入運行。
      4. When the thermal protection of the motor continuously acts, it is necessary to find out whether the fault is from the motor or overload or the setting value of the protection device is too low. After the fault is eliminated, it can be put into operation.
      5、注意棱角處不要過多的擦磨,否則會造成棱角表皮層脫落。
      5. Pay attention to the edges and corners do not rub too much, or it will cause the angular epidermis to fall off.
      6、在運行過程中觀察是否有異常響動,如有異常噪音,需通知技術人士進行維護保養。
      6. Observe whether there is abnormal noise during operation. If there is abnormal noise, the technician shall be informed for maintenance.
      7、因門體始終處于扭簧拉力狀態,如需修理維護等工作,需聯系技術人士操作
      7. As the door body is always in the tension state of torsion spring, if repair and maintenance work is needed, contact technical personnel for operation
      8、使用前應由工作人員有效調試好后,方可對門體進行運行操作。
      8. Before use, the door can be operated only after the effective debugging by the staff.
      以上就是關于造成電動卷簾門邊角脫落的8個原因介紹,希望對大家有所幫助,如您想了解更多內容請點擊網站:濟南車庫門http://www.halc9bit.com。
      The above is about the electric roller shutter door corner off the 8 reasons, hope to help you, if you want to know more, please click the website: Jinan garage door http://www.halc9bit.com 。

      推薦閱讀/ Recommended reading

      1、導軌1 Guide rail翻板車庫門當中的導軌采用的是鍍鋅鋼板,鋼板的厚度為1 5mm,它是經過一次性的操作而成形的。The guide rail in

      選擇卷簾門時可以借鑒什么 2021-10-27
      透視車庫門有什么樣的優缺點? 2021-10-19
      現代化的車庫門在設計方面要注意什么? 2021-10-15
      防盜車庫門的選購應該注意什么? 2021-09-25

      【本站圖片均由網站所有方提供,部分圖片來源于網絡,如無意中侵犯了某媒體或個人的知識產權,請來信或來電告之,本網站將立即刪除?!?/p>

      • 濟南九創門業有限公司
      偏僻农村大乱纶,亚洲夜夜性无码国产盗摄,国产免费看福利,国自产拍偷拍福利精品,东方亚洲欧A∨人在线