<var id="fwenz"></var>
<dd id="fwenz"><pre id="fwenz"></pre></dd>

  • <button id="fwenz"><acronym id="fwenz"></acronym></button>

    <legend id="fwenz"><noscript id="fwenz"></noscript></legend><small id="fwenz"></small>

      歡迎光臨濟南九創門業有限公司官網!

      聯系我們 收藏本站 在線留言

      新聞資訊

      首頁>>新聞資訊>>如何維護車庫門才能提高利用率?
      新聞資訊
      聯系我們
      濟南九創門業有限公司

      聯系人:李經理

      電話:15006519345

      網址:www.halc9bit.com

      地址:濟南市天橋區北園大街372號大明家居3F-A-10

      如何維護車庫門才能提高利用率?

      來源:http://www.jnhsjlm.com 日期:2020-08-28 發布人:guanli
        現在,隨著汽車制造業的發展,私家車越來越多。人們有了車后,會在家里建一個小車庫來放自己的車。建造車庫時,需要安裝車庫門。那我們應該如何做才能延長車庫門的使用壽命?下面是小編對于這個問題提出的幾點建議。
        Nowadays, with the development of automobile manufacturing industry, more and more private cars are used. When people have a car, they will build a small garage at home to put their cars. When building a garage, you need to install a garage door. What should we do to prolong the service life of the garage door? Here are some suggestions for this problem.
        1、在軌道上噴灑潤滑油:
        1. Spray lubricating oil on the track:
        在軌道上噴灑石墨粉,在轉軸上噴灑國產潤滑油或硅樹脂,或在軌道和轉軸上噴灑車庫門專用潤滑油進行潤滑。如果有皮帶輪,用旋轉軸上使用的相同潤滑劑進行潤滑。
        Spray graphite powder on the track, spray domestic lubricating oil or silicone resin on the rotating shaft, or spray special lubricating oil for garage door on the track and shaft for lubrication. If there is a pulley, lubricate it with the same lubricant used on the rotating shaft.
        2.擰緊所有松動的螺釘:
        2. Tighten all loose screws:
        找出松動的零件并擰緊。在上部電梯門上,檢查裝有彈簧的平板,確保螺絲擰緊,并擰緊松動的螺絲。在卷簾門上,請檢查將所有松動的螺釘固定在一起的鉸鏈,并更換損壞的鉸鏈。有時門會向一邊傾斜,這通??梢酝ㄟ^修理鉸鏈來糾正。如果螺絲孔變大,請更換相同直徑但更長的螺絲,并在中空纖維棒上涂上木工膠。然后裝上一個新螺絲。如果鉸鏈處的木材有裂縫,請拆除鉸鏈,用填孔劑填充裂縫和螺絲孔,并在填孔劑干燥后更換鉸鏈。
        Identify loose parts and tighten. On the upper elevator door, check the spring loaded flat plate to make sure the screws are tight and tighten the loose screws. On roller shutter doors, check the hinges that hold all loose screws together and replace damaged hinges. Sometimes the door tilts to one side, which can usually be corrected by fixing the hinge. If the screw hole becomes larger, replace the screw with the same diameter but longer, and coat the hollow fiber rod with wood glue. Then install a new screw. If there are cracks in the wood at the hinge, remove the hinge, fill the crack and screw hole with hole filler, and replace the hinge after the filler is dry.
        3.檢查彈簧:
        3. Check the spring:
        在上部電梯門上,每一側的彈簧都懸掛在凹槽中,彈簧鉤移動到相鄰的凹槽中以調節它們的彈性。在卷簾門上,兩邊的彈簧由滑輪上的彈簧纜線控制。為了調節彈簧的彈性,請加長穿過門上板的纜線,然后在末端再次打結以維持彈性。如果卷簾門中間只有一個扭簧,請不要試圖修理,因為彈簧的彈性太大,可能會受傷。對于使用這種彈簧的門,應該向維修服務部門尋求幫助。
        On the upper elevator door, the springs on each side are suspended in the grooves, and the spring hooks move into the adjacent grooves to adjust their elasticity. On the roller shutter door, the springs on both sides are controlled by the spring cable on the pulley. In order to adjust the spring elasticity, lengthen the cable through the door upper plate, and then tie the knot again at the end to maintain the elasticity. If there is only one torsion spring in the middle of the rolling shutter door, please do not try to repair it, because the spring is too elastic and may be injured. For doors using this spring, you should seek help from a professional maintenance service department.
                濟南車庫門廠家
        4.清潔軌道污垢:
        4. Clean track dirt:
        小編認為可以用高濃度家用清潔劑清潔履帶,清除污垢和硬化油脂,清潔旋轉軸,然后干燥履帶和旋轉軸。
        Xiaobian thinks that high concentration household detergent can be used to clean the track, remove dirt and hardened grease, clean the rotating shaft, and then dry the track and rotating shaft.
        5、檢查金屬軌道:
        5. Check metal track:
        檢查車庫中的金屬軌道,并檢查將軌道固定在墻上的安裝支架。如果支架松動,擰緊螺栓或螺釘并關閉車庫門。檢查車庫中的軌道是否凹陷、彎曲或變平。如果有任何損壞,請用橡膠錘或廢木墊錘敲擊這些地方。如果軌道嚴重損壞,那就需要進行更換了。
        Check the metal rails in the garage and check the mounting brackets that hold the rails to the wall. If the bracket is loose, tighten the bolts or screws and close the garage door. Check whether the track in the garage is sunken, bent or flattened. If there is any damage, tap these places with a rubber hammer or waste wood cushion hammer. If the track is seriously damaged, it needs to be replaced.
        6.確保軌道在水平線上:
        6. Make sure the track is on the horizontal line:
        用水平儀檢查軌道,確保它們在同一水平線上。水平軌道應該稍微傾斜到車庫后面。如果是卷簾門,軌道的縱向部分應完全垂直。在車庫的墻上,兩條軌道得在同一高度。如果導軌沒有正確對齊,請松開固定安裝支架的螺釘或螺栓,但不要將其拆下。然后小心地敲打軌道,并將它們移動到正確的位置。用水平儀重新檢查導軌,確保它們處于正確的位置。
        Check the tracks with a level to make sure they are on the same level. The horizontal track should tilt slightly behind the garage. In the case of rolling shutter doors, the longitudinal part of the track shall be completely vertical. On the garage wall, the two tracks have to be at the same height. Do not loosen the bolts if they are not properly aligned. Then carefully tap the tracks and move them to the correct position. Recheck the guide rails with a spirit level to make sure they are in the correct position.
        以上是濟南車庫門廠家關于如何延長車庫門使用壽命提出的六點建議。如您還有其他疑問歡迎咨詢我們的http://www.halc9bit.com網站。
        The above is Jinan garage door manufacturers on how to extend the service life of garage doors put forward six suggestions. If you have any other questions, please contact us http://www.halc9bit.com Website.

      推薦閱讀/ Recommended reading

      車庫門常見問題 Garage door FAQs 進行一些車庫門故障排除可以大大維護門的結構和功能。盡管有些問題您可能無法自行進行維修,但仍有一些

      車庫門電機保養知識介紹 2022-01-07
      有關車庫門的相關知識 2022-01-06
      車庫門保養你知道多少? 2021-12-24
      常見到的車庫門類型與特點 2021-12-23

      【本站圖片均由網站所有方提供,部分圖片來源于網絡,如無意中侵犯了某媒體或個人的知識產權,請來信或來電告之,本網站將立即刪除?!?/p>

      • 濟南九創門業有限公司
      偏僻农村大乱纶,亚洲夜夜性无码国产盗摄,国产免费看福利,国自产拍偷拍福利精品,东方亚洲欧A∨人在线